 |
 |
 |
|
|
|
[Sponsors] | ||||
Why does ANSA's mesh consume an exaggerated memory in fluent |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 8, 2020, 23:41
|
Why does ANSA's mesh consume an exaggerated memory in fluent
|
#1 |
|
Member
Mostafa
Join Date: Sep 2016
Posts: 30
Rep Power: 9  |
Hello everyone
I'm not sure what I'm doing here but for the same geometry and same number of elements, the mesh created by ANSA takes much longer to calculate on fluent than the mesh created by ANSYS meshing. Is that normal? Also, and more importantly, when I enable coupled solver in fluent, ANSA's mesh causes it to crash, claiming I don't have enough memory (32Gb for 18 thousand elements only) And for the same mesh created using ansys it runs smoothly! Is there anything I should watch out for or just they are not compatible? Thank you 
|
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| foam-extend-4.1 release | hjasak | OpenFOAM Announcements from Other Sources | 19 | July 16, 2021 05:02 |
| [ICEM] Error reading 2D hybrid ICEM mesh into Fluent | Kloz | ANSYS Meshing & Geometry | 1 | June 6, 2016 13:45 |
| [ICEM] Fluent reading wrong mesh type | Tommorrice | ANSYS Meshing & Geometry | 1 | March 15, 2016 17:32 |
| [mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
Linear Mode
