How to delete triple cons

VenkatRaj · November 21, 2023, 09:37

I am beginner in ANSA software. I am facing difficulties to delete triple cons. Can any one explain step by step process to delete tripple cons

vangelis · April 19, 2024, 10:46

Hi there
Triple CONS indicate that 3 or more Faces are connected on the same line.

It could be either duplicate or overlapping faces, Triple T-junctions etc

You can either Delete some Faces, so that you only leave two Faces connected, or release the connectivity using Hot Points Release to disconnect the area

November 21, 2023, 09:37	How to delete triple cons	#1
VenkatRaj New Member VENKATESH Join Date: Nov 2023 Posts: 1 Rep Power: 0	I am beginner in ANSA software. I am facing difficulties to delete triple cons. Can any one explain step by step process to delete tripple cons

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Action Subtract or delete doesn't work in OpenFOAM	TGS	Main CFD Forum	1	August 16, 2023 10:52
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[ICEM] Delete family part not possible	FluidCFD	ANSYS Meshing & Geometry	6	April 4, 2014 08:57
Fuel Triple Points	arun	OpenFOAM Programming & Development	0	August 17, 2010 00:38
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

April 19, 2024, 10:46		#2
vangelis Senior Member Vangelis Skaperdas Join Date: Mar 2009 Location: Thessaloniki, Greece Posts: 287 Rep Power: 22	Hi there Triple CONS indicate that 3 or more Faces are connected on the same line. It could be either duplicate or overlapping faces, Triple T-junctions etc You can either Delete some Faces, so that you only leave two Faces connected, or release the connectivity using Hot Points Release to disconnect the area