|
[Sponsors] |
May 16, 2012, 13:19 |
First layer height - units
|
#1 |
Senior Member
---------
Join Date: Oct 2010
Posts: 303
Rep Power: 17 |
Could some one please tell me if the units for the parameters like first layer height (or) total height in the prism mesh set up (or) the spacing in hex meshing are consistent with the units of the mesh
I mean if the mesh is in mm then does a setting of 0.1 for the first layer height also refers to 0.1 mm.
__________________
Best regards, Santhosh. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh - no layer added | bejbro | OpenFOAM Meshing & Mesh Conversion | 5 | February 1, 2020 20:05 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 12:41 |
[snappyHexMesh] Boundary layer generation problems | ivan_cozza | OpenFOAM Meshing & Mesh Conversion | 0 | October 6, 2010 13:47 |
Height of boundary layer | DAK565656 | CFX | 2 | April 19, 2007 11:30 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |