 |
 |
 |
|
|
|
[Sponsors] | ||||
March 1, 2013, 07:05
|
Prism mesh error
|
#1 |
|
Senior Member
S.Bogoda
Join Date: Jul 2012
Posts: 133
Rep Power: 13  |
Dear All,
I am trying to mesh attached geometry. Geometry: I have two curved sections within 1mm gap and made perforations. Gaps between perforations and curved sections are closed by surfaces. Problem: I can make the tetra mesh but when improving it by prism mesh it always stuck. I have selected "cone hole walls" for select parts for prism layers. Can anybody help me to fix this problem? Thank you. |
|
|
|
|
|
March 1, 2013, 07:18
|
|
#2 |
|
Senior Member
S.Bogoda
Join Date: Jul 2012
Posts: 133
Rep Power: 13 |
More explanation:
My requirement is to create perforated cone. I used wall thickness as 1mm and therefore created two surfaces to define walls and grilled holes on there. Then I closed all holes by surfaces. |
|
|
|
|
|
|
March 1, 2013, 11:02
|
|
#3 |
|
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
recently, i've been using a new approach, going back to designmodeler, and make just a sector of your geometry, 10 degree or something, go back to icem cfd. using hexa or tetra, mesh it, it will take less time either ways
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
| [OpenFOAM] Saving ParaFoam views and case | sail | ParaView | 9 | November 25, 2011 15:46 |
| DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |
| user defined function | cfduser | CFX | 0 | April 29, 2006 10:58 |
| error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |
Linear Mode
