|
[Sponsors] |
May 16, 2012, 12:11 |
Wing body tutorial with tetra + prism
|
#1 |
Senior Member
|
Here is the my little effort regarding the meshing of DLR-F6 using the techniques (slight modification and addition) in the form of youtube tutorials (five parts). The salient features of this five part tutorial are:
1. Global settings for the shell meshing, prism meshing and volume meshing 2. curve parameters setting using the dynamic, general and copy parameters mode. 3. Part mesh setup for global meshing parameters. 4. Shell meshing on surface 5. Use of repsect line elements and try harder features for difficult surfaces. 6. Prism meshing 7. Density box 8. Volume meshing 9. Two step smoothing operation 10. Writing boundary condtion and mesh file for Fluent 11. Setup and run problem in Fluent with Advanced settings. Features 1-9 are taken from the ANSYS ICEM CFD 14.0 training material and therefore credit goes to guys at ANSYS. Hoever step 10-11 are created by me. Part I http://www.youtube.com/watch?v=BW2r1...ature=youtu.be Part II http://www.youtube.com/watch?v=DFI-K...ature=youtu.be Remaining three parts are being uploaded, shall provide links as soon as they are uploaded. |
|
May 16, 2012, 12:52 |
Part 3
|
#2 |
Senior Member
|
||
May 16, 2012, 15:17 |
Part 4
|
#3 |
Senior Member
|
||
May 16, 2012, 15:43 |
Part 5
|
#4 |
Senior Member
|
Last edited by Far; May 17, 2012 at 00:48. Reason: updated link |
|
November 30, 2012, 06:45 |
|
#5 |
New Member
Mattia
Join Date: Oct 2012
Location: Milan
Posts: 28
Rep Power: 14 |
Hello, your tutorials are very interesting. Compliments.
Can you send me the initial geometry file? Because I'm trying to create a mesh around an ONERA M6 wing but I have several problems with this. I have seen your videos and I have "copied" step by step you but I have a different result. Thanks a lot. Best regards. Mattia |
|
March 1, 2013, 12:53 |
|
#6 |
Senior Member
|
I have been asked by someone on youtube to share the exact geomtry used for the video tutorial. http://www.youtube.com/watch?v=BW2r1...mment_received
Geometry is here Geometry is taken from ANSYS ICEM CFD workshops. PS: I am sorry for delayed reply |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM - problems with prism mesh | João Lourenço | CFX | 2 | September 18, 2019 04:07 |
[snappyHexMesh] Meshing 3D wing (hydrofoil) fails | klausb | OpenFOAM Meshing & Mesh Conversion | 0 | December 28, 2011 15:26 |
Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 08:06 |
ICEM - Prism Tool Problem | carpe85 | CFX | 0 | February 10, 2009 13:25 |
Icemcfd: Preventing prism inflation collisions? | Joe | CFX | 1 | July 31, 2007 10:13 |