Effect of Symmetry BC on results
Please refer to this thread I had going in the FLUENT forum.
Basically, for an airfoil analysis (inviscid model), the presence of the symmetry BC on the two sides of the C-mesh gave bad results for the lift coefficient (40% deviation from wind tunnel data), while changing it to inlet gave good results (within 5%). Did someone experience this before? And why did this happen? |
Can you past the corresponding mesh files?
|
Quote:
|
ICEM files, if they are created in ICEM.
|
Are these good?
|
All times are GMT -4. The time now is 18:53. |