CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] Inflation - Mesh Quality (

saideepakb May 26, 2012 09:14

Inflation - Mesh Quality

I am trying to simulate the flow over an airfoil (using CFX), and for that I am using inflation to resolve my boundary layer in the Ansys Workbench Meshing. I have observed that as I increase the resolution of the inflated mesh, my element quality is decreasing (0.03).

So my question is whether it will have any influence on my final results, if yes, how do I increase its quality?


All times are GMT -4. The time now is 10:40.