 |
 |
 |
|
|
|
[Sponsors] | ||||
June 14, 2012, 09:51
|
3D Sweeping
|
#1 |
|
New Member
Join Date: Jun 2012
Posts: 1
Rep Power: 0  |
Hi,
I'm trying to sweep a geometry on two planes. I can do this no problem when the sketch is drawn on one plane, but can't figure out how to do it on two planes. Firstly, is there any way of combining two sketches, then sweeping the resulting path. Or, do I need to create two separate sweeps and merge them? Attached is a screenshot of where I am so far. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] sweeping 2D Boundary Layers | nore | ANSYS Meshing & Geometry | 13 | June 27, 2012 02:48 |
| Force vectors for drag during sweeping motion | aamer | FLUENT | 0 | April 18, 2011 08:17 |
| Negative Drag in Sweeping motion | aamer | Main CFD Forum | 1 | April 16, 2011 07:01 |
| UDF for sweeping wing | aamer | Main CFD Forum | 0 | December 16, 2010 07:35 |
| GAMBIT - Creating and meshing face by sweeping | Woo Meng Wai | FLUENT | 3 | July 23, 2008 08:17 |
Linear Mode
