CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [DesignModeler] 3D Sweeping (

athom June 14, 2012 09:51

3D Sweeping
1 Attachment(s)
I'm trying to sweep a geometry on two planes. I can do this no problem when the sketch is drawn on one plane, but can't figure out how to do it on two planes.

Firstly, is there any way of combining two sketches, then sweeping the resulting path.
Or, do I need to create two separate sweeps and merge them?

Attached is a screenshot of where I am so far.

All times are GMT -4. The time now is 09:24.