|June 18, 2012, 06:29||
Quad Meshing on Surface
Join Date: Nov 2011
Posts: 19Rep Power: 7
Using DM in Ansys and trying to mesh a turbine blade with a rotating boundary. Inflatiojn layer and boundaries and the mesh looks good but cant seem to get the surfaces of the blade to mesh using quad cells rather than tets. I want quads near the surface which will move out to a tet mesh further out. At present its meshing with tets at the near wall region for the blades and this is resulting in more cells needed. If I can use quads for blade surface it will half the cells needed in the near wall region which is good.
Its probably a simple fix but some help would be very much appreciated from a newbie to these forums but have used their help a bit in the past.
Attached pic of surface mesh at present.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM?||jash||ANSYS Meshing & Geometry||19||July 23, 2013 18:48|
|Shared surface between bodies for better meshing?||alxe||ANSYS Meshing & Geometry||5||August 18, 2011 11:52|
|Meshing one surface inside the other||premns||OpenFOAM Other Meshers: ICEM, Star, Ansys, Pointwise, GridPro, Ansa, ...||4||June 30, 2011 04:11|
|Surface Repair for Meshing||Andy R||Main CFD Forum||13||May 3, 2008 14:33|
|Interpolating volume data onto quad surface mesh||N.R.||CFX||6||June 7, 2007 08:15|