Meshing advice needed??
 

Hi,

I am to do a study on spray droplet sizes. I need to create & mesh a spray chamber using Design Modeler & ANSYS meshing. Can someone advice me on how to start this? Thanks!

First do the Tutorials. Send an email, I will send you DM and AM training notes.

Thanks for replying =)

Well, I've tried some tutorials before this. And after that, went on to try to work on my case...but I can't seem to create the geometry correctly. Creating the spray chamber is fine, it's just a cylinder. But incorporating the injector nozzle exit at the starting end is what I'm having difficulty with.

Hi,

I'm not sure if you have received my email. You may send the training notes to me at carol.skye@gmail.com

Thanks a lot.