Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] meshing for a square

Mark Forums Read

Reply

Search this Thread

June 29, 2012, 07:05	meshing for a square	#1
zaynah04 Senior Member zaynah K. Join Date: Jun 2012 Location: Mauritius Posts: 138 Rep Power: 13	hi all am new user of gambit. am currently doing flow over a cube in 2d, but each time i change the edge mesh settings something goes wrong. my question is how do i mesh the edges? i mean i have so many edges and i dunt know the actual procedure on how to change the interval count and first lengt double sided etc.. thanks in advance

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Right approach for meshing of square with circle	Far	ANSYS Meshing & Geometry	3	October 25, 2011 10:18
tetrahedral meshing in square channel	Aashutosh Magdum	FLUENT	4	May 28, 2005 20:27
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 11:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 11:08

All times are GMT -4. The time now is 21:18.