Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ICEM] polar coordinates possible in ICEM?

Mark Forums Read

Reply

Search this Thread

July 6, 2012, 12:20	polar coordinates possible in ICEM?	#1
despaired student Senior Member Sören Join Date: Mar 2012 Posts: 102 Rep Power: 14	Hi, I have a short question, not worth opening a new thread for it... Can I place a point in ICEM 14.0 by polar-coordinate? If yes, how? Kind regards, Sören

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to print out coordinates of cells in Icem	mrMunson	ANSYS	4	May 3, 2012 08:53
[ICEM] Exporting Cartesian coordinates from ICEM to Matlab?	user_of_cfx	ANSYS Meshing & Geometry	0	October 17, 2011 10:17
Neumann Boundary Condition for Poisson Equation solution in Polar Coordinates	prapanj	Main CFD Forum	2	July 30, 2011 19:07
Polar coordinates in Fluent	Ergys Rexhepi	FLUENT	0	January 9, 2009 07:04
How to edit point coordinates in ICEM?	Alexey	CFX	6	December 24, 2007 10:31

All times are GMT -4. The time now is 02:36.