CFD Online Logo CFD Online URL
Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] Meshing a circular arc airfoil with close boundary

Register Blogs Members List Search Today's Posts Mark Forums Read

LinkBack Thread Tools Display Modes
Old   July 6, 2012, 18:34
Default Meshing a circular arc airfoil with close boundary
New Member
Join Date: Jan 2012
Posts: 9
Rep Power: 8
Benrode is on a distinguished road
Hi, Please I have been tying to mesh this profile for some time.
I am new to CFD, I could not use blocking for the airfoil section. I used surface mesh for the airfoil section
1) I want to know if the mesh that I have created is ok as seen in the picture, the quality is 0.44.
2) I could not get the leading edge to be perfect curve as shown in the attached picture(I need guide on how to do this).
If it is ok , I could not get a good results (lift (Negative) and drag are very high) when I ran the simulation in fluent.
I will also need a guide on how I can use the blocking method to be able to compare my results.
Thank you
Attached Images
File Type: jpg 1.jpg (94.9 KB, 16 views)
File Type: jpg 2.jpg (89.7 KB, 11 views)
File Type: jpg 3.jpg (96.4 KB, 8 views)
File Type: jpg 4.jpg (97.4 KB, 8 views)
Benrode is offline   Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
error message with modeling a cube with a hold at the center hsingtzu OpenFOAM Native Meshers: blockMesh 2 March 14, 2012 10:56
CFX13 Post Periodic interface EtaEta CFX 7 December 8, 2011 18:15
[GAMBIT] Boundary Meshing on Splitting Geometry tav98f ANSYS Meshing & Geometry 4 June 3, 2010 16:16
simulating an airfoil using a moving boundary Alejandro FLUENT 2 February 10, 2007 00:46

All times are GMT -4. The time now is 07:25.