[ICEM] Question about creating lateral surface for a specific geometry

lnk · July 11, 2012, 17:01

Hi,

May I ask why I can't create the lateral surface of this geometry by the button 'simple surface'? And how to fix this problem? Btw, the upper side of the edge of this geometry is not round but the lower side is.

Best regards and many thanks,
lnk

BrolY · July 12, 2012, 03:43

Sometimes, this option doesnt work very well, but I don't know why.
Anyway, instead of using the method "from 2-4 curves", use the method "from curves". This method works better than this other

lnk · July 12, 2012, 06:14

Quote:

Originally Posted by BrolY

Sometimes, this option doesnt work very well, but I don't know why.
Anyway, instead of using the method "from 2-4 curves", use the method "from curves". This method works better than this other

Thank you very much. It works.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Problems with coedge curves and surfaces	tommymoose	ANSYS Meshing & Geometry	6	December 1, 2020 11:12
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible	velan	OpenFOAM Meshing & Mesh Conversion	3	October 22, 2015 11:05
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
[snappyHexMesh] Layers don't fully surround surface	EVBUCF	OpenFOAM Meshing & Mesh Conversion	14	August 20, 2012 04:31
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

July 12, 2012, 03:43		#2
BrolY Senior Member AB Join Date: Sep 2009 Location: France Posts: 323 Rep Power: 21	Sometimes, this option doesnt work very well, but I don't know why. Anyway, instead of using the method "from 2-4 curves", use the method "from curves". This method works better than this other