|
[Sponsors] |
[ANSYS Meshing] Is there always fault in ICEM tcl scripting? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 14, 2012, 14:37 |
Is there always fault in ICEM tcl scripting?
|
#1 |
Senior Member
lnk
Join Date: Feb 2011
Location: Switzerland
Posts: 118
Rep Power: 15 |
Hi,
I'm using tcl scripting to parameterize complex geometry. But one bug always happens. I don't know it's mistakes made by me or there's fault from the software. The script worked at the first time. Then I didn't do anything to that script. But when I run it again later, there's error. May I ask if any of you have the same experience at tcl scripting? Best regards and many thanks, lnk |
|
July 14, 2012, 15:00 |
|
#3 |
Senior Member
lnk
Join Date: Feb 2011
Location: Switzerland
Posts: 118
Rep Power: 15 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] ICEM Scripting Issues | tylerplowright | ANSYS Meshing & Geometry | 33 | September 27, 2021 16:35 |
[ICEM] Scripting language version for ICEM 14.0 on win 7 64 bit | Far | ANSYS Meshing & Geometry | 10 | August 26, 2014 05:46 |
[ICEM] Question about the use of ICEM tcl scripting | lnk | ANSYS Meshing & Geometry | 9 | January 16, 2013 09:24 |
[ICEM] Scripting language version for ICEM 14.0 on win 7 64 bit | Far | ANSYS Meshing & Geometry | 3 | May 21, 2012 14:09 |
ICEM CFD Scripting | Prakash.Paudel | ANSYS Meshing & Geometry | 2 | August 17, 2011 15:53 |