[ANSYS Meshing] how to mesh multiparts as one body

yahya · July 14, 2012, 19:52

I trying to mesh the flow inside a separator
I have a cylinder full of a fluid with two surface plates as internals
When i meshed it i found that each part was meshed alone
so i want to know to connect the meshing as one part
in order to notice the influence of the plate on the flow behavior

the attachment shows the separator that I'm meshing

Gweher · July 16, 2012, 00:13

Just form a single part in DesignModeler. In the outline tree, select all your parts under Part section, then right click >Form New Part, this will fix your problem

yahya · July 16, 2012, 02:48

Thx alot i used it and it worked😃

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to set periodic boundary conditions	Ganesh	FLUENT	15	November 18, 2020 06:09
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	4	September 3, 2014 05:25
Mesh motion with Translation & Rotation	Doginal	CFX	2	January 12, 2014 06:21
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 14:09
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10

July 16, 2012, 00:13		#2
Gweher Senior Member Gwenael H. Join Date: Mar 2011 Location: Switzerland Posts: 392 Rep Power: 20	Just form a single part in DesignModeler. In the outline tree, select all your parts under Part section, then right click >Form New Part, this will fix your problem

July 16, 2012, 02:48		#3
yahya Member yahya Join Date: Jul 2012 Posts: 43 Rep Power: 13	Thx alot i used it and it worked😃