 |
 |
 |
|
|
|
[Sponsors] | ||||
July 19, 2012, 10:22
|
2D Sweep Method
|
#1 |
|
New Member
Austin Murch
Join Date: Jul 2012
Location: Duluth, MN, USA
Posts: 13
Rep Power: 12  |
.I’ve been working on a 2D section of the wing airfoil and flap element. As you may know, CFX can’t handle 2D meshes, so the workaround given by ANSYS is to use a Sweep method to generate the one element thick mesh. I’ve found that meshing success is very unpredictable- one set of mesh settings will work fine, and then I make a seemingly innocuous change such as expanding the outer air boundary and the meshing will fail. Any advice on 2D problems or Sweep methods?
Thanks! |
|
|
|
|
 |
| Tags |
| airfoil, airfoil2d, cfx 14, sweep |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Method: Sweep with Quads | peterputer | ANSYS Meshing & Geometry | 0 | July 18, 2012 13:22 |
| [Gmsh] discretizer - gmshToFoam | Andyjoe | OpenFOAM Meshing & Mesh Conversion | 13 | March 14, 2012 04:35 |
| Fluent 6.3.26 vs 12.1 and partition method | Anorky | FLUENT | 0 | April 27, 2010 10:55 |
| Comparison: Finite Volume Method vs. Analytic Method | m-fry | Main CFD Forum | 1 | April 20, 2010 14:40 |
| Code for most powerfull FDV Method | D.S.Nasan | Main CFD Forum | 6 | September 4, 2008 02:08 |
Linear Mode
