CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] Question about ICEM mesh output to CFX (

lnk July 27, 2012 15:39

Question about ICEM mesh output to CFX
1 Attachment(s)
Hi everyone,

Here is my problem. I generated mesh by ICEM. Then I output my mesh to CFX-Pre in format of cfx5. Then I changed my mesh at ICEM and output it again. I used CFX-Pre to input the new cfx5 mesh but CFX-Pre still showed my old mesh. Here is an example at the attachment. For this case, I refine the cube mesh and then use the 'output' button to output the mesh. But it still output the mesh before mesh refinement.

Could you please tell me how to solve this problem?

Best regards and many thanks,

All times are GMT -4. The time now is 01:50.