|
[Sponsors] |
[ANSYS Meshing] Question about ICEM mesh output to CFX |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 27, 2012, 16:39 |
Question about ICEM mesh output to CFX
|
#1 |
Senior Member
lnk
Join Date: Feb 2011
Location: Switzerland
Posts: 118
Rep Power: 15 |
Hi everyone,
Here is my problem. I generated mesh by ICEM. Then I output my mesh to CFX-Pre in format of cfx5. Then I changed my mesh at ICEM and output it again. I used CFX-Pre to input the new cfx5 mesh but CFX-Pre still showed my old mesh. Here is an example at the attachment. For this case, I refine the cube mesh and then use the 'output' button to output the mesh. But it still output the mesh before mesh refinement. Could you please tell me how to solve this problem? Best regards and many thanks, lnk Last edited by lnk; July 28, 2012 at 18:33. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about mesh copy for periodic geometry at CFX | lnk | CFX | 5 | May 10, 2014 09:16 |
ICEM to CFX (maybe rookie) question | TheBearJew | ANSYS | 4 | March 9, 2013 08:00 |
[ICEM] Question about ICEM script for mesh generation | lnk | ANSYS Meshing & Geometry | 3 | July 23, 2012 15:03 |
How to create a mesh use ICEM in CFX? | little stone | CFX | 3 | July 17, 2012 20:33 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 12:45 |