Mesh refinement
Hi
After the Pre-Mesh quality was adjusted well ( the quality was above 0.5 ), I used the button 'Pre-mesh Params -> Refinement' to refine the pre-mesh. Then I check the quality of the pre-mesh. The quality becomes bad again. If I convert them to mesh firstly, then use the mesh refinement button, this problem may still occur. May I ask how to solve this problem? |
Hello Anna,
do you have solved this problem? In my case, icem puts some thin elements between the zones after the refinement. |
All times are GMT -4. The time now is 19:50. |