|August 11, 2012, 13:28||
Join Date: Aug 2012
Posts: 1Rep Power: 0
hey is any one whold help me could help me out?????
i'm working on model design of chasis of BAJA vehicle after importing my pro-e model in ansys workbench 12 it shows problematic geometry after meshing. wat could b the reasons?????????
cn any1solve it?
its very urgent
|January 18, 2016, 17:26||
Join Date: Apr 2014
Location: On Leave!!!!!!!!!!!!!!
Posts: 516Rep Power: 6
right click on "mesh" and see problematic geometry and rectify it.
If you are not able to locate the problematic geometry then change your view to "wireframe" and then right click to see geometry again! It should highlight the problematic geometry now.
Try to give reasonable sizing and inflation to get a good mesh.
Post your pic showing your problematic geometry for better answers!
|Thread||Thread Starter||Forum||Replies||Last Post|
|problematic geometry||Electrico||ANSYS Meshing & Geometry||2||October 22, 2013 11:52|
|DesignModeler, filling pipes and problematic geometry||Cipherflak||ANSYS||1||March 29, 2012 17:39|
|Problematic Geometry||fatb0y||CFX||15||October 13, 2010 17:17|
|problematic geometry||Electrico||FLUENT||0||May 3, 2010 12:15|
|vitual _ real||deneb||FLUENT||3||January 22, 2007 05:31|