Some hints required on blocking geometry
 

Previously I learned about the blocking topology of swept wing from Far and no now I have to learn about the blocking of F6 Wing with fuselage. I now the same blocking topology will work fine for this case but I am confused how O-grid or C-grid will be inserted in this case. Some tips and advices required on how to insert C-grid and where to make splits in the C-grid for good blocking. I am attaching the .prj file with the post. Thanks in advance.

Regards

In fact, original ideas are due to Simon.

Zip file only contains the .prj (project file). You need to attach the .tin file at least.

.tin size was of large size that's why I only attached .prj file but what's the point? If you open project file into ICEM it just behave like .tin file after opening so that you can make any changes to it isn't it?

If you go to the ANSYS Customer Portal there is a PDF file in the tutorials section for version 11, in it is a tutorial for blocking an aircraft similar to the F6. That might help you.

Are you air_engineer_arsenal ;):p Admin plz don't allow double accounts from same IP :D

what is going on here !!!!! :eek: