 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Skeewed elements in Workbench |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 22, 2012, 14:44
|
Skeewed elements in Workbench
|
#1 |
|
New Member
Volkan
Join Date: Jul 2012
Posts: 1
Rep Power: 0  |
Hi everyone.
I am working on aerodynamics analysis of a 3D ground vehicle for my MS. thesis but I have a problem with the skeewed elements with a value of about 0.96. at the end of the meshing. These elements are between the tyre and the road (edeges of the contact region). The mesh generally looking good but unfortunately I couldn't handle with these skeewed elements. you can see the geometry with the skeewed elements at the attachments. I hope you will help me. 1.jpg 2.jpg 3.jpg |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ANSYS Workbench on "Uncertified" Linux Distros | hsr | CFX | 289 | April 20, 2023 09:23 |
| [ANSYS Meshing] Workbench 13: Structured Hexa Meshes | rooftop | ANSYS Meshing & Geometry | 19 | March 31, 2016 02:33 |
| Penetrating elements in extruded mesh | Michael P | CFX | 2 | May 20, 2005 08:06 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
