 |
 |
 |
|
|
|
[Sponsors] | ||||
September 7, 2012, 15:27
|
Converting .msh to .dbs
|
#1 |
|
New Member
Paul
Join Date: May 2012
Posts: 23
Rep Power: 13  |
Is it possible to convert a .msh FLUENT mesh to a .dbs GAMBIT file? Is there any software to do this?
|
|
|
|
|
|
September 10, 2012, 07:15
|
|
#2 |
|
Senior Member
Marion
Join Date: Jul 2012
Location: France
Posts: 122
Rep Power: 14 |
Hi,
I don't know if it is possible, but I have never succedded. I think this is because the mesh file only contains information about nodes and connectivity (and the boundary conditions), but nothing about geometry (edges, faces, volumes). At the time I did not want to lose any time over this, so I just started from scratch! Marion. |
|
|
|
|
|
|
September 10, 2012, 08:27
|
|
#3 |
|
Senior Member
Rick
Join Date: Oct 2010
Posts: 1,016
Rep Power: 26 |
Import (file->import) the msh file into gambit as fluent 5/6 and save it as dbs, or save the cas file in fluent and import the cas into gambit.
Daniele |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] using .dbs files in ICEMCFD | audunsy | ANSYS Meshing & Geometry | 4 | March 2, 2015 06:41 |
| [Commercial meshers] failed checkMesh after converting from .msh: non closed cells | phsieh2005 | OpenFOAM Meshing & Mesh Conversion | 11 | September 20, 2012 08:51 |
| Import mesh .msh in FreeFem++ | teolong | Main CFD Forum | 0 | July 22, 2011 13:40 |
| [Other] Converting .CGNS to .MSH | arapha | ANSYS Meshing & Geometry | 4 | October 20, 2010 12:36 |
| .msh file cann't be by Fluent | nchuche | FLUENT | 1 | June 29, 2010 10:38 |
Linear Mode
