 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] How to make geometry and meshing |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 29, 2012, 08:54
|
How to make geometry and meshing
|
#1 |
|
New Member
upendra kumar shukla
Join Date: Sep 2012
Posts: 27
Rep Power: 13  |
Hi,
My system is like this: There is a rotating cylinder and below it at some distance concentric cylindrical burner which is moving along the length of rotating cylinder for providing heat to the cylinder. I am new in ansys CFD .Can anybody help me how to make this system in design modular and mesh it. Thanks in advance. Regards |
|
|
|
|
|
| Tags |
| ansys design modular |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 04:25 |
| [ANSYS Meshing] Using more than one meshing method on a single 2D geometry | robbierich90 | ANSYS Meshing & Geometry | 0 | October 30, 2011 13:12 |
| Reg difficulties in meshing the geometry...Urgent | arunraj | ANSYS Meshing & Geometry | 0 | August 26, 2011 23:25 |
| [ICEM] Meshing on a Complicated Geometry | tav98f | ANSYS Meshing & Geometry | 2 | August 17, 2011 11:15 |
| [Gmsh] Problem meshing an imported geometry | Alicia | OpenFOAM Meshing & Mesh Conversion | 0 | March 30, 2010 04:53 |
Linear Mode
