|
[Sponsors] |
October 7, 2012, 10:02 |
extrude cyclone
|
#1 |
New Member
Marek
Join Date: Mar 2012
Posts: 5
Rep Power: 14 |
Hi
I have a problem with extrude the top of the cyclone. I can not draw a spiral angle (Appendix 1 - so it should look like). As Annex 2 send drawn by me in DesignModeler the cyclone with the traditional spiral inlet (+ Appendix 3 - jpg). As Annex 4 I put something about it in a spiral that DesignModeler - but only as lines drawn. If anyone has any ideas, I would ask for help. Thanks in advance. Regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Steam-Water Vertical Cyclone Separator | Munggang | FLUENT | 3 | April 29, 2014 13:38 |
[Gmsh] Cannot get the right mesh from gmsh | JinBiao | OpenFOAM Meshing & Mesh Conversion | 2 | August 31, 2010 04:51 |
How to extrude 2D Mesh in ICEM CFD? | VSB | CFX | 7 | December 27, 2006 11:58 |
How to mesh the worm-inlet cyclone | Fuping Qian | FLUENT | 0 | July 7, 2005 03:59 |
Modelling Industrial cyclone behaviour | Günther Hasse | Main CFD Forum | 3 | October 12, 1999 19:34 |