Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[DesignModeler] Fill command with valve inside

Updated Threads

Reply

Search this Thread

October 25, 2012, 01:28	Fill command with valve inside	#1
Orb Member Join Date: Jan 2012 Posts: 52 Rep Power: 14	I cannot get the fill command to work with a valve piece inside. It just fills over the valve instead of creating empty interfaces where the valve is. Any ideas?

October 25, 2012, 02:26		#2
Orb Member Join Date: Jan 2012 Posts: 52 Rep Power: 14	Figured it out, needed to use the Boolean subtract command

Reply

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Simulation of air flow inside valve - FSI? Help!	farianka	Main CFD Forum	0	April 17, 2011 16:30
OpenFOAM on MinGW crosscompiler hosted on Linux	allenzhao	OpenFOAM Installation	127	January 30, 2009 19:08
Modelling the Heat flow inside the curing oven	Marios Vlad	CFX	1	February 6, 2008 07:11
[Technical] Flow inside a valve	danvica	OpenFOAM Meshing & Mesh Conversion	0	December 9, 2007 11:04
meshing F1 front wing	Steve	FLUENT	0	April 17, 2003 12:37

All times are GMT -4. The time now is 19:48.