|October 23, 2012, 16:32||
fixing of geometry
Ugly Kid Joe
Join Date: Aug 2010
Posts: 193Rep Power: 8
I would like to join the 2 surfaces that are denoted by a yellow border. I have attached the images with this post.
I have tried a couple of things but none seem to work. any help is kindly appreciate. The geometry it self was broken when I imported it to ICEM.
Thank you very much.
|October 23, 2012, 20:24||
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Blog Entries: 23Rep Power: 21
my be setting a higher tolerance in the build topology will work, if not, this will work:
Create one point in one of those curve.
Create a second point in the other curve. (use project point on curve) so they can be aligned.
next create an edge between these two points.
After that create a surface using the driven curve. select circular curve as driven, then edge as driver (i dont remember the names first one is driven for sure don't remember the second) .
I hope you got my point.
If not share you geometry i can help you do that.
New to ICEM CFD, try this document --> https://goo.gl/KAOIwm
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem Importing Geometry ProE to CFX||fatb0y||CFX||3||January 14, 2012 20:42|
|STL Surface Geometry Fixing||EphemeralMemory||Main CFD Forum||2||October 31, 2010 14:35|
|Problem meshing an imported geometry||Alicia||Open Source Meshers: Gmsh, Netgen, CGNS, ...||0||March 30, 2010 04:53|
|Simulation of Flow through Complex 3D Geometry||EmersonKB||CFX||5||July 2, 2009 08:17|
|vitual _ real||deneb||FLUENT||3||January 22, 2007 05:31|