|
[Sponsors] |
October 30, 2012, 16:57 |
get rid of negtive mesh
|
#1 |
New Member
Guan
Join Date: Dec 2011
Location: US
Posts: 25
Rep Power: 14 |
The geometry is not so complicated.
I spent two days to get rid of the negative values. but still no success. could anybody help me? |
|
October 31, 2012, 07:40 |
|
#3 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
if it's not association. then the problem comes from law bunching in the edges. one edge has different bunching than the one parallel to her. may be you forgot to apply "copy to parallel edge"...
|
|
October 31, 2012, 07:59 |
|
#4 | |
New Member
Guan
Join Date: Dec 2011
Location: US
Posts: 25
Rep Power: 14 |
Quote:
Right now, I believe the association is fine. The whole domain is basically a "T" with two converging nozzle facing each other inside the "T". I attached tin file. |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface | Kryo | OpenFOAM Meshing & Mesh Conversion | 13 | February 17, 2022 07:34 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
Converting Starccm+ mesh | Ladnam | OpenFOAM | 0 | September 14, 2011 06:30 |
2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |
basic of mesh refinement | arya | CFX | 4 | June 19, 2007 12:21 |