[Pedro Di Giovanni]

Hello,
I have this domain to mesher on ANSYS CFX, the domain have 4 body and represent ¼ of a symmetric geometry.




I need to created inflation layers in some regions like the figure bellow.



In Design Modeler, I use the Projection Tool to device one Face in many like the photo.


The previous results (Figura 2) are obtained with just one Body, but I need to create a similar result with a domains of 4 body, like the first imagem
When I go to Mesher and trayng to build the inflation layers on the especif regions I can’t have the espected result.



Some one can help me?

Sorry by my English.

[scipy]

I don't think this is actually possible in ANSYS Meshing. Might be with some further slicing into the big part and then "forming new part" in DesignModeler, but you might not be able to get the inflation layers to go around corners in a multibody part.