CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [TGrid] Tutorial batch mode studies (

turbodede November 8, 2012 05:31

Tutorial batch mode studies
Hi guys
Iīm new in this forum and Far told me that this is the right place for my question about the turbogrid tutorials.
I have problems in launching the session file because when I run in the launcer the script and write: perl <scriptname> the computer give me a syntax error and I donīt know where is the problem. As further info I can tell you that I followed the tutorial literarly but maybe I missed something.
I donīt think that perl is installed in this computer. Maybe is this the problem?

Thanks for your answer.
best regards

All times are GMT -4. The time now is 04:26.