|
[Sponsors] |
November 13, 2012, 05:38 |
|
#22 |
Senior Member
S.Bogoda
Join Date: Jul 2012
Posts: 133
Rep Power: 13 |
Dear Far,
Yes I did. As you can see there is a connection with cone and the cylinder. Cylinder is extending into bottom. (Actually the geometry is a cyclone separator) I used two blocks (merged) to block them. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[DesignModeler] Sweeping or surface meshing in enclosure? | Edu-R | ANSYS Meshing & Geometry | 9 | January 23, 2013 13:41 |
Shared surface between bodies for better meshing? | alxe | ANSYS Meshing & Geometry | 5 | August 18, 2011 11:52 |
[ICEM] Automatic mesh generation script surface intersection problem | stuart23 | ANSYS Meshing & Geometry | 0 | May 13, 2011 01:10 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |