[DesignModeler] problem with "blend" command to smooth trailing edge -- CFD Online Discussion Forums

March 2, 2021, 04:07

problem with "blend" command to smooth trailing edge

Noel_91

New Member

Ettore

Join Date: Feb 2021

Posts: 3

Rep Power: 5

Hello,

i'm designing a centrifugal compressor and i'm new to ansys CFD. From the simulations I did I found high trails near the trailing edge. For this I would like to smooth it with the "blend" command. I state that the geometry is generated through bladegen. The problem is that when I click on "Exportpoints" it takes all the blades except the surfaces modified with "blend". How can I do, to insert these changes in "exportpoint"?

thank you

Attached Images

	Cattura.PNG (85.5 KB, 5 views)
	Cattura1.PNG (81.6 KB, 6 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Trailing edge sensitivity anlaysis	JanH	SU2	2	November 23, 2018 13:53
[GAMBIT] GAMBIT edge problem	SJD	ANSYS Meshing & Geometry	4	February 26, 2014 15:56
Structured mesh of a 3d sharp trailing edge	Gilles	Main CFD Forum	2	May 23, 2008 13:23
The trailing edge velocity	maximus	Main CFD Forum	0	March 6, 2005 00:27
trailing edge problem	Kuo Wei-Jen	Main CFD Forum	2	April 14, 1999 10:09

All times are GMT -4. The time now is 18:48.