|November 19, 2012, 03:16||
Lamp holder meshing
Join Date: Nov 2012
Posts: 1Rep Power: 0
I got a lamp holder from CATIA. I set Virtual Topology, automatic pinch control and Terahedrons method in ANSYS MESHING, but ANSYS could not generate any mesh. Then, I tried the body sizing with element size of the holder part (0.001m). It meshed with element 16120029, but low quality(orthogonal quality min 0.0112, skewness max 0.99). It will take lots of time on calculating the result. How to deal with the setting with fine quality?
I also tried to do the slice in Geometry, but it did not work with slice off face.(Or I don't know how to use it) Some object contact with different surface. Is this a better way to slice the lamp holder into many parts and select individual one to mesh it?
Thanks in advance
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ANSYS Meshing] Can I use ANSYS Meshing for manual meshing?||Kirjain||ANSYS Meshing & Geometry||6||November 30, 2015 09:11|
|Best Meshing scheme for Cylinder||Nutrex||Main CFD Forum||4||July 29, 2008 11:03|
|Meshing locks workbench window.||andy2o||CFX||0||February 1, 2008 06:01|
|Singularity of grid?Volume meshing vs face meshing||Ken||Main CFD Forum||0||September 4, 2003 11:09|
|Volume Meshing & Face Meshing? singularity of grid||ken||FLUENT||0||September 4, 2003 11:08|