 |
 |
 |
|
|
|
[Sponsors] | ||||
November 28, 2012, 22:42
|
non-manifold bodies
|
#1 |
|
Member
yahya
Join Date: Jul 2012
Posts: 43
Rep Power: 13  |
I imported a geometry to the designmodeler that was created in GAMBIT software in order to edit the design.
The model can accept deleting parts or bodies or any kind of removing materials. However, any attempt to add any materials anywhere (even in regions away from the model) gives this error (non-manifold bodies) Any one knows how to solve this problem?? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Exhaust Manifold Transient Heat Transfer Simulation | Jonny6001 | STAR-CCM+ | 9 | February 22, 2017 13:24 |
| Exhaust Gas manifold simulation | shrinath | Siemens | 6 | September 5, 2013 16:26 |
| Arbitrary rigid bodies in coarse grid | DrummerB | Main CFD Forum | 8 | April 26, 2012 10:09 |
| Shared surface between bodies for better meshing? | alxe | ANSYS Meshing & Geometry | 5 | August 18, 2011 11:52 |
| need help with manifold analysis in fluent | anil1886 | FLUENT | 0 | August 29, 2009 10:29 |
Linear Mode
