[ANSYS Meshing] How to insert a interior surface mesh

jjperez · December 4, 2012, 08:19

Hello I'm a new user of ANSYS. Someone know how I can insert a interior surface mesh in a geometry? I must put the surface in the Designmodeler module or in the Ansys Meshing ?(these surface is a green surface inside the geometry, I attached a image to help you). I want make that to use these surface like a fan in a building ventiltion simulation.

Thank you.

diamondx · December 4, 2012, 09:06

create a plane there, draw your circle using sketch, then go to concept -> surface from edges (or sketch) and you will get it...

jjperez · December 4, 2012, 09:32

Hello Diamondx, i tryed that in Designmodeler, but when I try to mesh the created surface in ANSYS Meshing doesn't work and I can't mesh the geometry. I need put a value for the tickness of the created plane or configure specially these plane?

Thank you again!

jrunsten · December 5, 2012, 08:30

If you split (Slice) the cylinder you will automatically get an interface between the two halves. Just make sure the body is Frozen before you do so

December 4, 2012, 09:06		#2
diamondx Super Moderator Ghazlani M. Ali Join Date: May 2011 Location: Tokyo, Japan Posts: 1,385 Blog Entries: 23 Rep Power: 28	create a plane there, draw your circle using sketch, then go to concept -> surface from edges (or sketch) and you will get it... __________________ Regards, New to ICEM CFD, try this document --> https://goo.gl/KAOIwm Ali

December 5, 2012, 08:30		#4
jrunsten Senior Member Josef Runsten Join Date: Jul 2010 Location: Gothenburg, Sweden Posts: 188 Rep Power: 23	If you split (Slice) the cylinder you will automatically get an interface between the two halves. Just make sure the body is Frozen before you do so Far likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface	Kryo	OpenFOAM Meshing & Mesh Conversion	13	February 17, 2022 07:34
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[ICEM] Problem making structured mesh on a surface	froztbear	ANSYS Meshing & Geometry	4	November 10, 2011 08:52
[ICEM] Problem making structural mesh on a surface	froztbear	ANSYS Meshing & Geometry	1	November 10, 2011 08:52
basic of mesh refinement	arya	CFX	4	June 19, 2007 12:21

December 4, 2012, 09:32		#3
jjperez New Member JJ Perez Join Date: Feb 2012 Posts: 3 Rep Power: 14	Hello Diamondx, i tryed that in Designmodeler, but when I try to mesh the created surface in ANSYS Meshing doesn't work and I can't mesh the geometry. I need put a value for the tickness of the created plane or configure specially these plane? Thank you again!