[ICEM] Error: no existing mesh part specified

DoubleG · December 11, 2012, 10:11

When I make a geometry with closed surfaces and a material point within the domain, I get the following error:

"No existing mesh part specified. Please run "Tetra from Geometry" if you don't have any existing mesh"

Does anybody know what's wrong?

I usually don't have this error. When I do this geometry just after a reboot it works fine, but it seems to happen just after running one specific mesh.

Thanks in advance,
Gerrald

Rikki-Tikki-Tavi · August 7, 2017, 07:32

I have this Problem as well. Does anyone know the answer to this?

vinguva · February 22, 2019, 06:22

Hi,

I came across the error too. Make sure you build the topology using the geometry functions in ICEM before creating parts and generating the volume mesh.

Regards
vinguva

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Hexa mesh, curve mesh setup, bunching law	Anorky	ANSYS Meshing & Geometry	4	November 12, 2014 00:27
[snappyHexMesh] external flow with snappyHexMesh	chelvistero	OpenFOAM Meshing & Mesh Conversion	11	January 15, 2010 19:43
basic of mesh refinement	arya	CFX	4	June 19, 2007 12:21
Icemcfd 11: Loss of mesh from surface mesh option?	Joe	CFX	2	March 26, 2007 18:10
How to control Minximum mesh space?	hung	FLUENT	7	April 18, 2005 09:38

August 7, 2017, 07:32		#2
Rikki-Tikki-Tavi New Member Join Date: Jun 2017 Posts: 8 Rep Power: 8	I have this Problem as well. Does anyone know the answer to this?

February 22, 2019, 06:22		#3
vinguva New Member Join Date: Feb 2015 Posts: 9 Rep Power: 11	Hi, I came across the error too. Make sure you build the topology using the geometry functions in ICEM before creating parts and generating the volume mesh. Regards vinguva