 |
 |
 |
|
|
|
[Sponsors] | ||||
December 20, 2012, 08:28
|
2D Airfoil Meshing (Ogrid)
|
#1 |
|
Member
Mamdouh
Join Date: Dec 2012
Location: Calgary, Alberta, Canada
Posts: 39
Rep Power: 13  |
Hi everybody,
I am a new ANSYS user, working on a family of 2D airfoils. I tried to simulate the famous tutorial ... https://www.youtube.com/watch?v=EknKVAJGEJ8 but I failed in the Ogrid step and constantly received the errors message as "Ogrid is not succesful" It will be strongly appreciated if any of you have an advise or suggestions to pass this step. Thanks in advance Mamdouh |
|
|
|
|
|
December 22, 2012, 11:45
|
|
#2 |
|
Super Moderator
|
See this please.
I followed the same steps as mentioned in Simon's video, including additional splits on air-foil due to high curvature. Last edited by Far; December 22, 2012 at 12:00. |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [GAMBIT] Problematic meshing of an inverted airfoil | snkutta | ANSYS Meshing & Geometry | 2 | October 11, 2011 13:23 |
| [Other] Ansys meshing airfoil and / or compressor blades | baw192 | ANSYS Meshing & Geometry | 8 | September 23, 2011 00:43 |
| Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
| Oscillating Airfoil - Dynamic meshing or user-defined velocity profile. | DarrenC | Main CFD Forum | 5 | July 19, 2010 22:33 |
| [GAMBIT] Meshing airfoil using .dat file problem | creggie | ANSYS Meshing & Geometry | 10 | June 27, 2010 19:24 |
Linear Mode
