[ICEM] Meshing Problem

John C. · January 3, 2013, 04:08

Hey Folks,

happy new year! I'm making a small gap analysis and therefore i have a part of a circlegeomtry which I tried to block and mesh.

I have done a similiar part last year but not with the kind of arc. Normally i would think that there should not be a problem and most of the blocking and meshing did work without any prolbems. (At least it is an easy geometry)
But there is a small wall where the mesh does not fit like it should be (See attached files).

I have attached also the project file, if the pictures are not meaningful enough.

Kind regards
John

John C. · January 3, 2013, 05:48

When I started last year with this task it was just not working. But now, after some time to think about it and to get a new perspetciv i found the problem :-).
There was just a edge missing, don't know where it went. I did a new blocking and now it's working. Really annoying if the problem was such a simple one and I did not catch it because the blocking is so unclear.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with querying the meshing database in CFX-Pre	ashtonJ	CFX	18	April 18, 2023 23:49
[Other] Hex meshing problem DM12	patrick	ANSYS Meshing & Geometry	7	January 9, 2015 07:21
Strange ANSYS Meshing 13.0 Problem	brunob	ANSYS Meshing & Geometry	3	June 21, 2011 20:03
Meshing problem in GAMBIT	Vidya Raja	FLUENT	0	May 20, 2006 23:31
GAMBIT meshing problem	Gauthier Lambert	Main CFD Forum	1	August 3, 2000 09:22

January 3, 2013, 05:48		#2
John C. New Member Join Date: Nov 2011 Posts: 6 Rep Power: 14	When I started last year with this task it was just not working. But now, after some time to think about it and to get a new perspetciv i found the problem :-). There was just a edge missing, don't know where it went. I did a new blocking and now it's working. Really annoying if the problem was such a simple one and I did not catch it because the blocking is so unclear.