|
[Sponsors] |
January 9, 2013, 11:02 |
meshing
|
#1 |
Senior Member
tmeysam92
Join Date: Jun 2011
Posts: 135
Rep Power: 14 |
Hello,
I want to mesh the valve (Fig.1) in ICEM. If you look at the geometry (Fig. 2), you see that there is a hole in it, but when i use blocking startegy , I do not know how to produce the hole in blocking. what should i do? thanks in advance. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |