CFD Online Discussion Forums
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] Negative volumes (https://www.cfd-online.com/Forums/ansys-meshing/112332-negative-volumes.html)

Far January 28, 2013 18:13
select solid block (inside plate) and slect optin around and click apply and your are done. If you have deleted the block inside plate then turn on VORF and send inner block to solid by creating new part.

Bollonga January 29, 2013 10:08
Quote:
Originally Posted by Far (Post 404659)
select solid block (inside plate) and slect optin around and click apply and your are done. If you have deleted the block inside plate then turn on VORF and send inner block to solid by creating new part.
Fine, it was just I was getting O-grid blocks all around the external contour. Thanks.


All times are GMT -4. The time now is 15:07.
Page 2 of 2 1 2
Show 40 post(s) from this thread on one page