[ICEM] Negative volumes

Far · January 28, 2013, 18:13

select solid block (inside plate) and slect optin around and click apply and your are done. If you have deleted the block inside plate then turn on VORF and send inner block to solid by creating new part.

Bollonga · January 29, 2013, 10:08

Quote:

Originally Posted by Far

select solid block (inside plate) and slect optin around and click apply and your are done. If you have deleted the block inside plate then turn on VORF and send inner block to solid by creating new part.

Fine, it was just I was getting O-grid blocks all around the external contour. Thanks.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] mesh airfoil NACA0012	anand_30	OpenFOAM Meshing & Mesh Conversion	13	March 7, 2022 17:22
[blockMesh] error message with modeling a cube with a hold at the center	hsingtzu	OpenFOAM Meshing & Mesh Conversion	2	March 14, 2012 09:56
channelFoam for a 3D pipe	AlmostSurelyRob	OpenFOAM	3	June 24, 2011 13:06
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00

January 28, 2013, 18:13		#21
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	select solid block (inside plate) and slect optin around and click apply and your are done. If you have deleted the block inside plate then turn on VORF and send inner block to solid by creating new part.