CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [DesignModeler] Can Anyone knows scaling reduction in DM? (

ssamton February 6, 2013 04:16

Can Anyone knows scaling reduction in DM?
Hi, everyone

I use ANSYS 14.5.

I have drawn some complex geometry by using CATIA.

I was imported that file in DM successfully.

However, I wanna reduce the scaling(or dimension) by 10, remaing same ratio all direction.

for example, the reference length is 10m, the reference height is 20m.

I want two other geometry, length and height 5m/10m, and length and height 1m/2m. surely, I also want to have reference geometry.

If the geometry is simple, scaling reduction geometry will draw newly. but that geometry is very complex, therefore I hesitated re-draw.

Anyone help me.


siw February 6, 2013 07:04

Will Create > Body Operation > Scale do the job? You'll need to read up on the DesignModeler guide so that you get the scale factor as you want.

diamondx February 6, 2013 09:23

@ siw, yes it will do the job, I've done it already.

All times are GMT -4. The time now is 18:53.