|
[Sponsors] |
February 6, 2013, 03:45 |
Blocking Problem with ICEM
|
#1 |
Senior Member
Himanshu Sharma
Join Date: Jul 2012
Posts: 101
Rep Power: 13 |
Hi,
I am trying to create hexahedral mesh for the following geometry attached by using blocking technique but i am unable to generate the mesh for the same actually i am unable to create an individual block for two cylinders on the square box. The after the creation of block also their are some lines left on the plain and therefore the mesh is not generated properly i am New to ICEM if somebody can provide few steps how to deal with blocking in case of my geometry. prob.1.JPG geo2.JPG |
|
February 7, 2013, 03:13 |
|
#4 | |
Senior Member
Himanshu Sharma
Join Date: Jul 2012
Posts: 101
Rep Power: 13 |
Quote:
I just want to make an hexahedral mesh in ICEM and take an output for fluent in .msh formate i want this because it will save the file in ASCII formate which i can import in Open Foam. It had been 3 days now that i am not able to do this silly job i am not able to undersand where my things are getting wrong please help me in doing so. Thanks Regards Himanshu Sharma Last edited by himanshu28; February 7, 2013 at 05:56. |
||
February 8, 2013, 08:47 |
Thanks and a Query
|
#6 | |
Senior Member
Himanshu Sharma
Join Date: Jul 2012
Posts: 101
Rep Power: 13 |
Quote:
i will edit that things.i have another doubt regarding the output of the mesh i want to use this mesh generated to be used in Fluent so what is the procedure for it presently what i am doing is as follows; 1.) going to solver ans selecting ANSYS fluent ans in second option choosing Ansys. 2.) Clicking output. But doing this i don't see any mesh conversion from hexa mesh converting to tetrahedral mesh.it has generated the .msh file and when i read that that file in fluent it still shows that hexahedrals cells only on the domain and in the mesh check. so please tell am i converting it in right way. Regards Himanshu sharma |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Multiple fluide zone in ICEM Hexa Block problem | ddqp | ANSYS Meshing & Geometry | 4 | October 9, 2013 10:57 |
[ICEM] Problem Meshing a Cylindrical sector in ICEM | SRead | ANSYS Meshing & Geometry | 4 | July 18, 2012 14:10 |
[ICEM] Simple meshing problem in ICEM | fkh | ANSYS Meshing & Geometry | 6 | February 14, 2012 13:01 |
Angle problems jet imipngement problem ICEM | rskrishna87 | ANSYS Meshing & Geometry | 2 | May 24, 2011 15:01 |
[ICEM] Problem on ICEM. | Eduardo | ANSYS Meshing & Geometry | 1 | October 5, 2009 10:52 |