CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Problem with cfx ERROR #001100279 (

TallesC February 7, 2013 09:56

Problem with cfx ERROR #001100279
I'm working on a pipe with knees, and the following issue is being presented in time to run in cfx:

* ERROR # 001100279 has occurred in subroutine ErrAction.
* Message: Floating point exception: Overflow

when creating the mesh in Icem I refined my knees and part of the next pipe, but the rest I leave the pipe with large elements. this would be the possible cause of the error reported above??

diamondx February 7, 2013 09:59

i don't think so , if cfx lets you import other format, like fluent msh files, try that ...

TallesC February 7, 2013 10:11

but this problem is being informed when I am putting to rotate, there'm thinking that the problem may be the mesh, you know?

diamondx February 7, 2013 11:51

i have no experience in CFX... try the cfx section of the forum

Far February 7, 2013 12:56

Refinement is 1:2 or 1:3?

TallesC February 7, 2013 14:47

the refinement was only using the edit paramt to increase the number of elements, any idea what is causing this problem?

TallesC February 7, 2013 16:08

guys, the probem was mesh, problem solve!!!thank you....

Far February 7, 2013 16:23

What was the problem?

TallesC February 7, 2013 16:29

how i`m thinkimg problem is large elements in the midle of pipe,I refine, its working!!!

All times are GMT -4. The time now is 19:55.