[DesignModeler] Uniting 9000 surfaces

JTT · June 5, 2018, 13:28

Hello,

I have a .dxf (and an .skp that won't load) of a train car that has ~9000 surfaces. I want to unite them to form a solid body, but doing Boolean Unites on the surfaces results in errors re: opposite normals. I could go through and change the normals one by one, but there must be a better way to do this.

Additionally, is there a way to do this better in CREO or SpaceClaim? Maybe AutoCAD?

I have attached an image of the train nose

TomD · June 6, 2018, 02:42

Spaceclaim has many features that might help you in this situation
you might be able to use stitch operation to create the solid body with one click. but if treating the surfaces as surfaces won`t work, Spaceclaim has special features for facet data such as yours. i`m not familiar with them but I would suggest reading more about the facet tab in the Spaceclaim help manual.

The link below might help as well:

http://www.spaceclaim.com/en/Support...Tutorials.aspx

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
NURBS surfaces on a wing	frossi	CFX	5	February 5, 2017 15:27
Specifying points for sampling surfaces in sampleDict	arieljeds	OpenFOAM Post-Processing	0	April 20, 2016 07:11
[snappyHexMesh] SHM not snapping to some surfaces	Swift	OpenFOAM Meshing & Mesh Conversion	13	January 4, 2016 01:56
[ANSYS Meshing] Surfaces with high curvature	mohammad	ANSYS Meshing & Geometry	9	November 24, 2014 01:02
Modeling both radiation and convection on surfaces - Ansys Transient Thermal R13	s.mishra	ANSYS	0	March 31, 2012 04:12

June 6, 2018, 02:42		#2
TomD New Member Tom David Join Date: May 2017 Posts: 17 Rep Power: 8	Spaceclaim has many features that might help you in this situation you might be able to use stitch operation to create the solid body with one click. but if treating the surfaces as surfaces won`t work, Spaceclaim has special features for facet data such as yours. i`m not familiar with them but I would suggest reading more about the facet tab in the Spaceclaim help manual. The link below might help as well: http://www.spaceclaim.com/en/Support...Tutorials.aspx