meshing help for v shaped model
 

Attachment 19030Attachment 19030Dear friends

Please find the attached geometry for your kind discussion. I am struggling to get quality mesh in the V shaped modelling.Actually the model is axisymmetry. I have taken 5 degree slice.

I need your kind attention to give some idea to get quality mesh near the sharp edge. I found the skewness near the edge is always 0.94 .


Thank you


Regards

Govind

use insert method -> multizone and insert mapped face see what it can do... may i ask why you choose only 5 degres ?

Thank you for your reply
The geometry is axisymmetry, I have chosen 5 degree slice to reduce memory requirement and solution time

I am trying to do 2 way fsi . The picture shown above is single object fluid modelling.I also tried mapped face meshing I could not rid of the skewness at the sharp edges . Any other option please.

Thank you
Govind

I assume you are using CFX for simulation. change to Fluent.