 |
 |
 |
|
|
|
[Sponsors] | ||||
February 27, 2013, 01:17
|
Hex mesh for tangential junction
|
#1 |
|
New Member
df
Join Date: Oct 2012
Posts: 4
Rep Power: 13  |
Hi,
I am new to ICEM meshing. I would like to mesh a tangential junction of two pipe with different diameters. The small pipe is connected tangentially to large pipe in a inclined angle of 27 degree. I tried to use ICEM to generate hex mesh but it not successful. Everybody has idea to mesh it? Thank you in advance |
|
|
|
|
|
February 27, 2013, 02:50
|
|
#2 |
|
Senior Member
AB
Join Date: Sep 2009
Location: France
Posts: 323
Rep Power: 21 |
Hexa or tetra ?
Show some pics of what you have tried. |
|
|
|
|
|
|
February 27, 2013, 16:29
|
|
#3 |
|
New Member
df
Join Date: Oct 2012
Posts: 4
Rep Power: 13 |
Hi BrolY
I use Hex mesh. I splited into 4 blocks as shown in (pic block) and associated the four edge to upper part of tangential curve (pic 1). - Associated the vertical edge to left tangential curve and edge to right tangential curve (pic 2&3) However, the upper face and front face is disappeared after re-meshed |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] --> FOAM FATAL ERROR: Trying to specify a boundary face | A.A. | OpenFOAM Meshing & Mesh Conversion | 41 | June 26, 2020 07:06 |
| [snappyHexMesh] SnappyHexMesh for internal Flow | vishwa | OpenFOAM Meshing & Mesh Conversion | 24 | June 27, 2016 08:54 |
| Mesh motion with Translation & Rotation | Doginal | CFX | 2 | January 12, 2014 06:21 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
| [blockMesh] apparently the mesh doesn't want to be created in one direction | Maxime Thomas | OpenFOAM Meshing & Mesh Conversion | 1 | August 18, 2012 06:05 |
Linear Mode
