|February 19, 2013, 15:05||
Flattening spheres with ANSYS Meshing
Join Date: Oct 2010
Posts: 2Rep Power: 0
I'm trying to generate a mesh for a geometry with a large number of particles. The particles are in contact (particle-particle and particle-wall), which is a problem for mesh generation. To solve this problem I need to flat the spheres (Fig1 attached).
I know that some Mesh Softwares can do this automatically, flattening the particles locally in regions where the distance between two surfaces falls below a predefined appropriate value.
Do you know if ANSYS Meshing or ICEM CFD allow to do this?
If I was not clear please let me know.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[DesignModeler] Ansys Geometry n meshing||Niru||ANSYS Meshing & Geometry||130||January 14, 2017 12:44|
|[ANSYS Meshing] Can I use ANSYS Meshing for manual meshing?||Kirjain||ANSYS Meshing & Geometry||6||November 30, 2015 09:11|
|[ANSYS Meshing] ANSYS Meshing vs. ICEM||oborona||ANSYS Meshing & Geometry||2||April 19, 2012 11:28|
|[ANSYS Meshing] Internal Wall in Ansys Meshing||swiss_zhang||ANSYS Meshing & Geometry||0||September 28, 2011 07:56|
|Ansys meshing||TypeSpeed||ANSYS||5||January 1, 2010 07:31|